Can't get roll to work on my controller...

Installation and usage on Linux / Installation unter Linux
Post Reply
zektiv
Posts: 1
Joined: 26 Apr 2015 00:44

Can't get roll to work on my controller...

Post by zektiv »

So I've connected my FlySky TH9X to my computer successfully using a USB dongle to the buddybox connector. When I start up, my terminal literally says "Linux plugin claims to have found 11 controllers" and once in the application, I can run the "configuration" utility to get the sticks to calibrate or whatnot.

I can see feedback (though it 'flickers' quite a bit) and most of the channels seem to work, but I can't get the roll (right stick, left/right motion, Mode 2) to show any feedback in the configuration. Sure enough, I can't quite control the multicopter because it won't read the channel. Any ideas?

Thanks!
User avatar
Michael
Posts: 1825
Joined: 25 May 2008 16:11
Location: Germany
Contact:

Re: Can't get roll to work on my controller...

Post by Michael »

When you have rev 1612 please download HELI-X again (Rev 1614). It is improved in the axis detection.

Michael
Post Reply