Page 1 of 1

FrSky TARANIS correct stick mappings for multirotor

Posted: 22 May 2014 22:51
by kahoona
Hi,

Hello World : )

I'm trying to configure my TARANIS(mode 2) sticks with HELI-X simulator. I am a little bit confused how the mappings of the sticks should go. What I have done so far is: created a model in my transmitter, assigned it with/as heli setup(?)(below pages templates) don't know if the assigning as heli is correct.. Maybe someone can verify that this should be done for multirotors. Succefully connected the transmitter and verified that control staples in HELI-X moves on input. So far so good.

Now to the more tricky part(since I'm new and not that familiar with the terminology yet hence the simulator); what does this really mean:

1.)Give maximal positive pitch and then move it back to the middle - should this be done on the left stick?

2.)Give maximum cyclic roll right and move it back to the center position - should this be done on the right stick?

3.)Give maximum cyclic pitch forward(nose down) and move the stick back - should this be done on the left stick?

4.)Move the rudder stick to maximal left value and then back to center position - should this be done on the left stick?

Any help is offcourse highly appreciated since I'm feeling a bit lost and googling this does'nt really give any good answers.

Thx in advance!
M

Re: FrSky TARANIS correct stick mappings for multirotor

Posted: 24 May 2014 06:51
by Michael
Hello,

there different modes to do this. Common is Mode 2. It works as follows:

1.)Give maximal positive pitch and then move it back to the middle - should this be done on the left stick?

Left stick forward

2.)Give maximum cyclic roll right and move it back to the center position - should this be done on the right stick?

right stick to the right

3.)Give maximum cyclic pitch forward(nose down) and move the stick back - should this be done on the left stick?

right stick forward

4.)Move the rudder stick to maximal left value and then back to center position - should this be done on the left stick?

left stick to the left


Have fun

Michael

Re: FrSky TARANIS correct stick mappings for multirotor

Posted: 24 May 2014 08:23
by kahoona
Hi Michael,

I will try these settings. Many thanks for your clearification friend : )

BR Mathias
Michael wrote:Hello,

there different modes to do this. Common is Mode 2. It works as follows:

1.)Give maximal positive pitch and then move it back to the middle - should this be done on the left stick?

Left stick forward

2.)Give maximum cyclic roll right and move it back to the center position - should this be done on the right stick?

right stick to the right

3.)Give maximum cyclic pitch forward(nose down) and move the stick back - should this be done on the left stick?

right stick forward

4.)Move the rudder stick to maximal left value and then back to center position - should this be done on the left stick?

left stick to the left


Have fun

Michael

Re: FrSky TARANIS correct stick mappings for multirotor

Posted: 30 May 2014 23:07
by kahoona
Many thanks Michael. I can confirm that your suggestions did work. Saved me some hours of work and also gave knowledge! Cudos.

BR Mathias