Rx2sim and Nine Eagles J6 Pro

[LordPePe]

Hello,

i try to use Heli-X 5 with my RX2SIM and my Nine Eagles J6 Pro transmitter (comes bundled with Solo Pro 180 3D helicopter). I connected the five servo channels form the receiver to the rx2sim adapter.
Now my problem is that the servo channels dont change separately. For instance when i move the pitch/throttle stick on the transmitter up, then those two channels move as expected, but also the aile and elev channels. The channels move like the servos in the helicopter, all together.
Is it possible with such a setup to use Heli-X? If yes, how?

Kind regards
Pepe

[Michael]

Hello

please switch off the mixers in the controller, either by choosing an airplane model or by setting the swashplate type to H1

Michael

[LordPePe]

Hi,

thank you very much. Switching to airplane mode worked. Is there also a way to turn off the integrated gyro inside the receiver?

Pepe