Re: Upgraded to Ver 6 - Trouble trying to get controller to
Posted: 12 May 2015 22:20
I'm not sure I understand. I want the throttle cut switch to work. It does in ver 5, but not in ver 6.
With ver 5, I have
z axis: collective pitch
slider: engine speed
And the throttle cut switch works fine.
So collective pitch and throttle are independent.
If I set them the same way in ver 6 and say OK and open the configuration window again, both of them are set to z axis.
And the throttle cut switch of course doesn't work.
With ver 5, I have
z axis: collective pitch
slider: engine speed
And the throttle cut switch works fine.
So collective pitch and throttle are independent.
If I set them the same way in ver 6 and say OK and open the configuration window again, both of them are set to z axis.
And the throttle cut switch of course doesn't work.